![]() ![]() ![]() How much space will be left on the calculator?Ģ. How would I update TI OS? (And how do I update nBoot?)Ħ. (presumably not related to nBoot) Can I extend the limit of ~100MB of storage on my calculator with BtMg?ĥ. Can I install nBoot and nLaunchy at the same time (to keep my dualboot)?Ĥ. Does nBoot permit me to keep my dualboot of CX 4.2 and CX CAS 3.1?ģ. Should I ditch nLaunchy and switch to nBoot on my revision A, and use whatever new features there are? (So far I've noticed overclocking, 4.3 "support", and Linux images on the calculator itself.)Ģ. CAS OS 4.4 on a non-CAS model, grab the cas_patcher_4.4.0.532.tns over there.CAS OS 4.5.0 on a non-CAS model, grab the cas_patch_4.tns over there.CAS OS 4.5.3 on a non-CAS model, grab the cas_patcher_4.5.3.14.tns over there.Only available for OSes 4.4, 4.5.0 and 4.5.3 so far : O9) If you sent a 3.9+ version non targeting your model, add the correct calculation patcher to the /ndless/startup/ folder.It's only mandatory for the 1st install-boot, this won't be needed again. After it reaches 100% and you get the OS grey loading screen, immediately press reset. Once the transfer is complete the calculator should restart to install the OS and launch it for the 1st time. O8) If you sent a 4.0.2+ version not targeting your model and are using Boot2 4.3.49, there is an additional mandatory step, or the OS is going to uninstall itself.O7) Now send the wanted OS - the OS should be accepted.Versions 3.6+ not targeting your model aren't going to work with a different Boot2 version. O6) Check that your calculator is booting on the CX Boot2 4.40.8 or 4.3.49 (shown on the top status line), and that the bottom status line is showing the name of the model targeted by the OS you want to intall.Your calculator may remove its current OS. ![]() (if you mess up, you can reset boot options by holding while typing ) O4) If it worked, store the options you've used as default boot options, by holding while pressing their number.typing if you need to switch the CX/CM model family.typing if you need to switch the CAS/numeric model type.If it differs from the model targeted by the OS you'd like to install, make it match by : O3) The bottom status line should display your currently set model : TI-Nspire CX, TI-Nspire CX CAS, TI-Nspire CM, TI-Nspire CM CAS.O2) Type to reset the minOS version to 0.0.0.O1) Call the ControlX menu by holding while pressing reset.Especially to install an OS not officially targeting your model : ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |